9.3. How to set the DOSER address?
- 1. SETTING UP THE POWDER DOSER
- 2. PROGRAMMING OF THE POWDER DOSER
- 3. REMOTE CONTROLS
- 4. CLEANING THE POWDER DOSER
- 5. FOR YOUR SAFETY
- 6. TECHNICAL SPECIFICATIONS
- 7. Accessories And Spare Parts
- 8. Powder Dosing – Guarantee
- 9. RS-COMMUNICATION PROTOCOL
To look up/modify the instrument address, disconnect the DOSER from mains.
Press the ADRS button continuously and at the same time connect the DOSER to the mains again. The message “A” and two numbers will appear on the display. This number from 00 to 99 is the current address of the powder dosing instrument.
To change the address press the buttons Λ Λ Λ under the display until the desired number is obtained.
To confirm and save the address, press the ON/OFF button.