3.3. PC control
If the instrument has been equipped with the optional RS-232 or RS-485 interface, it can be controlled digitally, e.g. from a PC by PNet control software.
To look up/modify the instrument address, disconnect the DOSER from mains. Press the ADRS button continuously and at the same time connect the DOSER to the mains again. The message “A” and two numbers will appear on the display. This number from 00 to 99 is the current address of the powder dosing instrument. To change the address press the buttons Λ Λ Λ under the display until the desired number is obtained. To confirm and save the address, press the ON/OFF button.