3.1. ON/OFF remote control

1. SETTING UP THE POWDER DOSER
2. PROGRAMMING OF THE POWDER DOSER
3. REMOTE CONTROLS
4. CLEANING THE POWDER DOSER
5. FOR YOUR SAFETY
6. TECHNICAL SPECIFICATIONS
7. Accessories And Spare Parts
8. Powder Dosing – Guarantee
9. RS-COMMUNICATION PROTOCOL

By interlinking the contacts no. 4 and 5 of the socket at the rear of the pump (see figure 61 and section 6.2), the powder dosing instrument will be blocked and the ON/OFF LED is off.

The same effect will be obtained by applying a voltage of 3 to 12 V DC to the contact no. 5 (0 line must be connected to contact no. 3). The remote control cable (Art. no. 4810) is used for the transmission of the remote control signals.

Remark: In some cases a reversed logic for the remote control might be desired. Please contact us in this case.